Comments on: Network card configuration missing after P2V using VMware Converter

By: Zero Signal

Zero Signal — Sat, 20 Feb 2010 03:39:12 +0000

Thanks! This was exactly what I needed.
(In my case, we had to disable the normal interfaces before it would display the hidden ones.)

By: Robert

Robert — Thu, 04 Feb 2010 00:28:37 +0000

Thank you very much for the post.

By: Matt

Matt — Tue, 27 Oct 2009 12:07:51 +0000

Thank you very much for the post. It was quite helpful!!

By: JM

JM — Mon, 26 Oct 2009 22:55:20 +0000

I ran into the same situation except the network tab will not show any dependents. Only Other devices with a ? Ethernet COntroller… On reboot- card is found but driver installation fails.

By: Rob

Rob — Tue, 06 Oct 2009 20:45:06 +0000

Thanks for the tip. I ran into a similar situation at one point.